General discussion about C3 Corvettes
1 post • Page 1 of 1
When I got my '74 there was no bumper cover on it, so I don't know how it goes together. I bought a replacement urethane bumper and while it's obvious where the support blocks go inside the vertical bars I can't figure out where the "face bar filler strips " go . The only place they seem to fit is inside the lower lip at the bottom of the cover, but they aren't shaped to curve up at the end and they're doesn't seem to be anything to hold them in place . They would also interfere with the plate that secures the lower lip . I have searched for hours and can't find any info, and the assembly manual I have doesn't show them. Does anyone know?