General discussion about C3 Corvettes
-
vito
- Senior Corvette Addict

- Posts: 1960
- Joined: Jun 22nd, 2010 11:32 am
- Tell us about your Corvette: 1972 Stingray Convertible , BB 454, 4-Speed.
- Location: Okinawa Japan
Post
by vito » Dec 31st, 2017 3:57 pm
Well the hood is on permanently, the gaps were a bit off as I forgot to install the radiator support shims.

The discharge line to the condenser sits too high and hits the front of the hood when I open it, so 1 either bend the pipe down or 2 recut the hole in the fender well to lift the back end of the pipe the the front end will pivot down. See if I can finish up the engine compartment this week and I will be happy.
Happy new year to you all.
