- Posts: 79
- Joined: Aug 2nd, 2013 5:41 pm
- Tell us about your Corvette: '72 LS5 coupe, 454, PS, PB, PW, AC, tilt/tele... in the middle of a frameoff restomod
- Location: St. Louis, MO
mndshp wrote:Thanks... I've heard others have had them pressed out, but I don't have access to a press. So then we're paying to get them pressed out, buying new ones, and paying to have the new ones pressed in... or buy my own press. Either way the rubber looks pretty good on mine... no cracks really to speak of... so maybe I'll just leave them in and save some money on this one!
sounds good... I was thinking along those lines when re-install ita66toy wrote:I missed this post. I beat mine out with a heavy ball pean hammer. When it came time to install the new ones I "had" to use a friends press. When I placed it back on the frame I used plumbers silicon grease on the bushing seating surface hoping that it will make it easier to get the cross member out to do a rear end swap.
Users browsing this forum: No registered users and 3 guests